Flush-Mount / In Ground Traffic Spikes

E-Z to Install Flush Mount / In-Ground Traffic Spikes

Powder Coated, Weld-Free Decking, Zinc-Free, & Exclusive Nite-Bite™ Reflective Tire Spike Tips. All bearing surfaces are super easy to replace! So you don’t have to replace the whole system when you have unavoidable wear and tear. Get decades of use out of our traffic spikes.

TireShark™ Flush Mount / In Ground Traffic Spikes.

Made in the USA. 25 Year Warranty. Mounts into the ground by creating a minimal cut into the roadway. Dramatically reduce labor costs of in ground traffic spike installations.

Flush Mount / In Ground Traffic Spikes

E-Z In Ground Traffic Spikes Installation!

2 Simple Steps:

1) Prepare the installation hole by cutting a small swath into the asphalt or concrete that is about 1/2” wider than the recessed part of the unit (depth approx. 12” total) and fill the hole with about 6” of coarse gravel for improved drainage.

2) Mix and apply catalyzed epoxy to the undersides of the upper support flanges. Lower the unit into place, making sure that the road surface is clean and dry where it will contact the adhesive.

Follow the adhesive manufacturer’s instructions, but hot weather or applied heat can have the in ground traffic spikes ready to drive across in as little as 2 hours.

We provide additional Instructions & Drawings for you: How to Install TireShark™ Flush Mount One-Way Traffic Spikes